engineering layers of copper
into advanced circuitry

 

 

We are currently testing the /2 Coffee Can tail lamp with a 14.00 volt source in a Grieves industrial oven.  The temperature is set at 140 degrees Fahrenheit ambient.  The test will be run for a minimum of 50 continuous hours.  There is no air flow inside the test chamber.  The /2 Coffee Can Taillight is operating at maximum current draw conditions;

  • Tail light on.
  • Brake light on.
  • 7 watt license plate bulb on.


Oops! Can't read the temperature? Neither could we.
Seems we went a bit over 140 degrees and buried the needle for a while.  The tail light didn't seem to care.


We got the oven dialed in to 140 degrees.
.

 

 

   
Cu Layer Inc. PCB Design Illinois CuLayer CuLayer.com Printed Circuit Board PCB Design Service Bureau Batavia Illinois PCB consulting PCB development PCB engineering PCB layout PCB routing LED Tail Light taillight BMW Ducati wiring harness wiring loom Ducati singles Ducati vintage old Ducati Motorcycle ASAP taillight As Small As Possible